Sticker Fab
3D Carbon / Black Rear Bumper Overlay - 2015-2021 Subaru WRX / STI
3D Carbon / Black Rear Bumper Overlay - 2015-2021 Subaru WRX / STI
Couldn't load pickup availability
3D Carbon / Rear Bumper Overlay
Add some unique styling with a minimum amount of effort and cost. Once applied, this product should last even longer than your car payments!
This is a vinyl product and has no actual carbon fiber content. Machine cut. This is NOT a universal product. The material has been cut down specifically for this application.
Installation
3D Carbon and matte black finishes are more resilient against scratches. While the black is much easier to work with than most black vinyl, please use extra care to not scratch it. Use a clean towel and an appropriate amount of wipe it down.
These install easily with a little water / soap. Clean the application area of your rear bumper. Leave a water / soap mixture on the surface of this area and apply the same mixture to the bottom of the overlay. This will make it easier to slide the overlay into position. Once even, squeegee out the remaining water / air bubbles. Be sure not to damage the material. Most of the time you can remove the bubbles with your fingers. Focus on the alignment of the visible edge of the vinyl. Contour the vinyl to the curve of the bumper. Allow 24-48 hours before washing vehicle.
Subispeed Install Video - Similar Product
Finishes
We have 3 choices for finishes. There's 3D Carbon Fiber, matte black, and black (pictured from left to right). Each product is rated between 5-6 years for outdoor durability.
The 3D Carbon Fiber and black materials have built in air egress channels which make them easier to install. However, the matte black is a very forgiving material when it comes to installation. Just take notes from the video above. For the 3D Carbon Fiber you can use products such as Armor all to clean it and keep it looking sharp. Always use a clean towel free of dust, debris, etc.
